September 13, 2017 1:56 am
- Check all downspouts and roof gutters to ensure they are securely fastened, free of debris and draining properly.
- Make sure yard culverts and street drains are free of debris and can carry water away as fast as possible.
- Consider installing a battery back-up pump that will operate in the event of a power failure.
- Inspect all floor drains throughout the house, including those in the garage, driveway, and basement.
- If you lose water pressure, open a faucet at the highest point in the house (such as an upstairs bathroom) to allow air into the system. Then draw water as needed from the lowest faucet in the home.
- Safe, clean water can be found in the water heater or a pressure tank for use in an emergency.
- If there is enough advanced warning of the emergency, assure the freshest water supply by flushing the tank and allowing it to refill with clean water.
- Turn off electricity or gas to the water heater so there is no risk that the heating unit could come on while the tank is being emptied. Draw water as needed from the drain valve at the bottom of the tank.
- Water stored in your home's plumbing system is safe - for a few days. After a longer time, it must be disinfected before it is used for drinking or cooking.
- Fill sinks and bathtubs with water for emergency use. Water stored this way is perfect for cleaning dishes, bathing or flushing toilets. However, due to the difficulty in getting tubs and sinks clean, this water is not recommended for drinking and cooking unless it is first disinfected.
For homes with basements:
- Inspect basement sump pump, if you have one. Ensure it is discharging water properly and is not clogged with debris. Do this by pouring a few buckets of water into your sump pit. In a matter of seconds, the pump should discharge the water and shut itself off. Consider installing a battery back-up pump that will operate in the event of a power failure.
Source: Benjamin Franklin
Published with permission from RISMedia.